nailing or screwing tongue and groove

How to Do Blind Nailing - YouTube

Mar 24, 2016 ... Leah demonstrates how the blind nailing technique for attaching "tongue and groove" wood boards to a floor, wall, or other surface. Support...

9 Common Subfloor Mistakes—and How to Avoid Them ...

Feb 17, 2015 ... Tongue-and-groove edges on many premium floor panels, such as ... Generally, nails (6d ring or screw shank, or 8d common) should be...

tongue & groove ptg flooring fixing guidelines - Metsä Wood

SOFTWOOD TONGUE AND GROOVE FLOORING SUITABLE FOR INTERIOR USE ... iv) in each case there should be two nails or screws per joist and the.

Pro Tips For Tongue & Groove Flooring - Extreme How To

Tips for tongue and groove flooring. ... Installing tongue-and-groove floors—engineered, pre-finished or bare wood—is among the most popular DIY projects, and for good reason. .... Or, you can use screws and plugs as an alternative.

Nail or Glue Wood Flooring Installation? - Wood and Beyond Blog

Jul 28, 2014 ... Nail-down installation is a straightforward way of fitting engineered or ... with either a nail, screw or staple, 15mm from the edge of the board. ... NOTE: with this type of installation, you don't need to glue the tongue and groove.

Flooring Fixing Methods: Secret Nailing | Direct Wood Flooring

May 4, 2018 ... As tongue and groove systems were brought in, secret nailing became ... As the new board is added, the 'groove' covers the nail or screw so it's...

ENGINEERED WOOD TONGUE AND GROOVE - Parquets Alexandra

ENGINEERED WOOD TONGUE AND GROOVE (CANADIAN) NAILED .... Tongue & Groove engineered ... Plywood must be nailed or screwed at all 4'' to 6''.

How to Install a Tongue and Groove Ceiling | The Family Handyman

Installing tongue-and-groove (aka T&G) boards is a fast, inexpensive way to panel ... 1×2 battens and fasten them directly to the framing with 2-1/2-in. screws.

Fasteners for Tongue and Groove Ceiling | Fine Homebuilding ...

Please suggest a nail fastener type and size for the installation of ... The cedar tongue and groove is nominal 1x6. ... The contractor wants to glue the boards in place in addition to the be blind screwing (small head trim srews).